NU-X Sculpture Mini Compressor Effects Pedal
Product
Information:
NUX Sculpture Compressor
NUX Sculpture Compressor pedal offers a consistent volume output
level and sharpens the signals on top and bottom edges. When you
start picking your guitar, it will clean the loud (peak) notes and
increase the sustain by raising the level of decaying (quiet) notes.
Sculpture also contributes to the signal foundation that’s fed into
the rest of your effects chain.
It has 2 clip modes, simply you can switch between “Clean Mode” and
“Clip Mode” by holding the switch for 1 second.
Clean Mode
The clean mode has a wide limit range from bottom to top so if your
guitar slams the limits too hard (like humbucker pickups) it is very
suitable to control the compression. You can also dial up a very
soft and clean compressor for single coil system guitars in Clean
mode.
Clip Mode (Clip Light is On)
If you want to squeeze your sound, Clip Mode will make it tight like
a cowgirl’s jeans and the compressor will wrap all over the signal.
It is very suitable for the single coil guitars to compensate the
weak output.
Blend Knob
When you adjust the knobs to catch a perfect balance between clipped
frequencies and a good sustain, blend circuit allows you to adjust
dry/wet compressor effect level on the processed signal. Whatever
you dial-up on Sculpture Compressor, you can simply adjust the
opacity of the effected sound.
True Bypass / Buffer Bypass
Sculpture Compressor has an embedded selectable buffer bypass.
You can change the bypass mode by turning on the power while holding
the footswitch.
Specifications:
●Input Impedance 1M ohm
●Output Impedance 20 ohm
●Power Input Standard 9V DC, center negative >100mA (power supply not included)
●Weight 174g/ 6 oz
●Dimensions 94(L)×51（w）×53（H）mm | 3.7(L)×2.0（W）×2.08（H）inches
