Furman Merit Series M-10Lx E Power Conditioner / Light Module – 10LxE
Product
Information:
A Merit Series Power
Conditioner is the perfect low-cost AC power
solution for any rack mount system. Install
an M-10Lx E in to the top slot of your rack,
and the ten switched outlets in the rear
panel will power up and protect all your
equipment up to a 10-amp load. The M-10Lx E
features two slide out, swiveling light
fixtures to provide discreet illumination of
your equipment on stages, in studios, and in
other dark places. A dimmer knob lets you
adjust the lamp brightness to just the right
level.
INSTRUMENT RIGS
You’ve got a rack for your effects, preamps, tuner…You’re going to plug that
into the wall? One big spike and your rig is up in smoke. Furman’s standard
level surge/spike protection defends your gear from the spikes and surges that
are so common at gigs and practice spots. With Furman’s standard level RFI/EMI
filtration, you’ll get a quieter tone without pops, crackles, and the local
radio station coming out of your amp. Plus, dual pull-out lamps let you see your
rack without turning the house lights on.
RECORDING
Can’t track down where that noise is coming from? Your mix sounding flat? With
Furman’s standard level RFI/EMI filtration you’ll lower the noise floor caused
by the dirty AC power coming into your console or DAW. Furman’s standard level
surge and spike protection keeps your sensitive digital equipment from acting
funny or burning up due to everyday spikes and surges. With a 10A capacity and
eleven total outlets, it’s enough to power your whole home studio.
DJ EQUIPMENT
Bars, clubs and other event venues have some of the worst power out there – from
air compressors turning on and off to light shows pulling current loads up and
down, the AC power can be a strain on the circuits in your rig. Furman’s
standard level protection and filtration keeps the bad stuff out and the dual
pull-out front panel lights let you discreetly see your board and gear without
distracting from the show on the dance floor.
PRO AUDIO
When you’re out there gigging, you never know what kind of power you’re going to
get. The wear and tear on mobile rigs eventually takes it toll – that’s why it’s
smart to plug into Furman’s standard level protection and RFI/EMI filtration. It
keeps your equipment safe and sounding clean. Whether you’re setting up a show
at the local club or powering up the church band for their next service, make
sure you give them power they can trust.
Specifications:
Maximum Output Current: 10 amps
Line Cord: 1.5 meter, removable, IEC C-13 female to Schuko male
Lamps: LED
Operating Voltage: 230VAC 50Hz
Spike Protection Mode: Line to neutral
Energy Dissipation: 305 joules
Peak Impulse Current: 12,000 amps
Maximum Continuous Operating Voltage: 650 Volts
Noise Attenuation: Transverse mode: Greater than 20dB, 1.5Mhz to 200 Mhz
Dimensions: 1.75” H x 19” W x 7.5” D
Weight: 2.3 kg.
Safety Agency Listing: CE
Warranty: Merit Series units are protected by a limited three year warranty
covering defects in materials and workmanship.
