Furman Merit Series M-10x E Power Conditioner – 10xE
Product Information:
A Merit Series Power
Conditioner is the perfect low-cost AC power
solution for any rack mount system. Install
an M-10x E in to the top slot of your rack,
and the ten switched outlets in the rear
panel will power up and protect all your
equipment up to a 10-amp load.
INSTRUMENT RIGS
You’ve got a rack for your effects, preamps,
tuner…You’re going to plug that into the
wall? One big spike and your rig is up in
smoke. Furman’s standard level surge/spike
protection defends your gear from the spikes
and surges that are so common at gigs and
practice spots. With Furman’s standard level
RFI/EMI filtration, you’ll get a quieter
tone without pops, crackles, and the local
radio station coming out of your amp. Plus,
dual pull-out lamps (M-10Lx E) let you see
your rack without turning the house lights
on.
RECORDING
Can’t track down where that noise is coming
from? Your mix sounding flat? With Furman’s
standard level RFI/EMI filtration you’ll
lower the noise floor caused by the dirty AC
power coming into your console or DAW.
Furman’s standard level surge and spike
protection keeps your sensitive digital
equipment from acting funny or burning up
due to everyday spikes and surges. With a
10A capacity and eleven total outlets, it’s
enough to power your whole home studio.
DJ EQUIPMENT
Bars, clubs and other event venues have some
of the worst power out there – from air
compressors turning on and off to light
shows pulling current loads up and down, the
AC power can be a strain on the circuits in
your rig. Furman’s standard level protection
and filtration keeps the bad stuff out.
PRO AUDIO
When you’re out there gigging, you never
know what kind of power you’re going to get.
The wear and tear on mobile rigs eventually
takes it toll – that’s why it’s smart to
plug into Furman’s standard level protection
and RFI/EMI filtration. It keeps your
equipment safe and sounding clean. Whether
you’re setting up a show at the local club
or powering up the church band for their
next service, make sure you give them power
they can trust.
Specifications:
Maximum Output Current: 10 amps
Line Cord: 1.5 meter, removable, IEC C-13 female to Schuko male
Operating Voltage: 230VAC 50Hz
Spike Protection Mode: Line to neutral
Energy Dissipation: 305 joules
Peak Impulse Current: 12,000 amps
Maximum Continuous Operating Voltage: 650 Volts
Noise Attenuation: Transverse mode: Greater than 20dB, 1.5Mhz to 200 Mhz
Dimensions: 1.75” H x 19” W x 7.5” D
Weight: 2.3 kg.
Safety Agency Listing: CE
Warranty: Merit Series units are protected by a limited three year warranty
covering defects in materials and workmanship.
